Submersible bore pump electrical

When a submersible pump is assembled one of the most critical things to get  right is the electrical connection that will spend its life under water.  Most submersible bores in Perth have this underwater connection done using a  heat shrink kit. The submersible motor has a factory installed “blue lead”  which is connected to the electrical cable that will come all the way up
from the pump to the bore head at the surface.

Crimping submersible bore electrical cable
Crimping submersible bore electrical cable

Seen here is the factory lead first being crimped to the electrical cable and then the waterproof heat shrink kit is applied. These are a series of sleeves which are essentially  shrunk over the cable joins provided a waterproof connection.

 Waterproof heat shrink joining motor lead to bore electrical cable
Waterproof heat shrink joining motor lead to bore electrical cable

A separate stainless steel cable holds the weight of the submersible pump so
no stress is placed on this electrical joint. Sometimes in old submersible bores incorrectly joined electrical cables can be a source of trouble. Our  bore electricians are well equipped to diagnose and repair any electrical
problem you may have with your bore or pump.

For repair or installation of replacement submersible pumps in any Perth suburb call us on 92460111 or 0408 454130. Further info about our Perth Water bore services and drilling of new bores can be found here.

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s