If your bore pump needs replacing and you live in Carramar or the surrounding suburbs of Wanneroo, Joondalup or Neerabup we can help you on 9246 0111.
Replace Water Bore Pump Perth
Submersible pumps are very reliable and normally don’t require any pre-emptive maintenance or repair. However, on occasion, they may be susceptible to lighting induction or fusion. It is best to get a specialist bore pump technician or electrician to repair or replace your submersible pump. It will save time and money when you do the job properly. We can also advise on whether any bore pump motor damage may be covered in your household insurance if you have fusion coverage.
Replace Water Bore Pump Carramar
Here we are replacing a 1.1 kW single phase submersible pump in the Perth suburb of Carramar. We also replaced 28 metres of downhole electrical cable with special rubberized bore cable and stainless steel draw wire in this 34 metre deep Carramar garden water bore.
Our specialist bore electrician will then return to install a junction box and test. Once the pump is up and running we will connect back to the reticulation and make sure all is OK.
If your Perth water bore and reticulation needs repair or replacement call us on 9246 0111 or get more information on bore repair HERE
Virgin Bores have just drilled a water bore at a home in Mount Pleasant.
The Mount Pleasant Water bore was drilled to 22 metres with a 1.1 kW submersible pump motor coupled with a multi stage wet-end.
The single phase water bore was electrically connected including a single phase start box.
We then plumbed it into the existing reticulation and disconnected the existing reticulation from the mains water supply,
If you live in Mount Hawthorn or the surrounding suburbs of Joondanna, Glendalough or North Perth call us on 9246 0111 or find out more here.
“That’s the good part of it…that’s your bore water”
Virgin Bore’s most experienced driller, George, is always pleased to see the first rush of bore water after drilling a water bore. Virgin Bores is always happy to deliver a plentiful supply of crystal clear water for their Perth customers.
Immediately after drilling a garden bore to the required depth, the bore is air developed as seen here. Even before the submersible pump is installed. Most garden bores drilled in Perth are drilled by the rotary mud method.
To clean out the drilling muds and “fines” we pump compressed air down inside the bore casing. At this stage air alone forces the groundwater up to the surface.
If you are considering a water bore and live in the greater Perth metropolitan area call on 9246 0111 or get a BORE QUOTE HERE
If your water bore in Perth needs maintenance, service or repair call on 9246 0111 or BOOK A BORE SERVICE HERE