All posts by BoreDoctor Perth

Perth's most experienced bore repairer. 1300 734 300 Call 24/7 Brett: 0411511611 Troy: 0408454130

Submersible Bore Pump Replacement Carramar

If your bore pump needs replacing and you live in Carramar or the surrounding suburbs of Wanneroo, Joondalup or Neerabup we can help you on 9246 0111.

Replace Water Bore Pump Perth

Submersible pumps are very reliable and normally don’t require any pre-emptive maintenance or repair. However, on occasion, they may be susceptible to lighting induction or fusion. It is best to get a specialist bore pump technician or electrician to repair or replace your submersible pump. It will save time and money when you do the job properly. We can also advise on whether any bore pump motor damage may be covered in your household insurance if you have fusion coverage.

Replace Water Bore Pump Carramar

Here we are replacing a 1.1 kW single phase submersible pump in the Perth suburb of Carramar. We also replaced 28 metres of downhole electrical cable with special rubberized bore cable and stainless steel draw wire in this 34 metre deep Carramar garden water bore.

Our specialist bore electrician will then return to install a junction box and test. Once the pump is up and running we will connect back to the reticulation and make sure all is OK.

If your Perth water bore and reticulation needs repair or replacement call us on 9246 0111 or get more information on bore repair HERE

New Water Bore Mount Pleasant

Virgin Bores have just drilled a water bore at a home in Mount Pleasant.

The Mount Pleasant Water bore was drilled to 22 metres with a 1.1 kW submersible pump motor coupled with a multi stage wet-end.

The single phase water bore was electrically connected including a single phase start box.

We then plumbed it into the existing reticulation and disconnected the existing reticulation from the mains water supply,

If you live in Mount Hawthorn or the surrounding suburbs of Joondanna, Glendalough or North Perth call us on 9246 0111 or find out more here.

Crystal Clear Bore Water

“That’s the good part of it…that’s your bore water”

Virgin Bore’s most experienced driller, George, is always pleased to see the first rush of bore water after drilling a water bore. Virgin Bores is always happy to deliver a plentiful supply of crystal clear water for their Perth customers.

Immediately after drilling a garden bore to the required depth, the bore is air developed as seen here. Even before the submersible pump is installed. Most garden bores drilled in Perth are drilled by the rotary mud method.

 

 

To clean out the drilling muds and “fines” we pump compressed air down inside the bore casing. At this stage air alone forces the groundwater up to the surface.

If you are considering a water bore and live in the greater Perth metropolitan area call on 9246 0111 or get a BORE QUOTE HERE

If your water bore in Perth needs maintenance, service or repair call on 9246 0111 or BOOK A BORE SERVICE HERE

 

Supply and Install Tap and PRV

Tap and PRV Brabham 

Virgin Water Bores recently drilled, cased, developed and gravel packed a 18 metre submersible bore in the Perth suburb of Brabham.

A .75 kW submersible motor was used for the Brabham water bore.

In the next few days after the drilling the electrician and reticulation team connect the new water bore to existing reticulation and bore box.

Water bore Brabham 

As pictured, we also supplied and installed a tap and pressure release valve.

If we can help you with water bore repair in Brabham or a new water bore in Brabham, call Troy on 9246 0111 or find out more here

DID YOU KNOW – the Perth suburb of Brabham is in the City of Swan. It was formerly known as Henley Brook. It was gazetted in 2011 and was named after Australian Motor Racing Champion Sir Jack Brabham (Source: Wikipedia)

Reviews for Virgin Water Bores

As it’s getting warmer in Perth we have been very busy with servicing and repairing water bores in Perth.

If you have any issues with your water bore call us on 9246 0111 or check out our website here

Thanks to these happy Perth customers for the great feedback for the Virgin Bores team.

Repair Shared Bore Ocean Reef

Driving around Perth at the moment you will see people back in their front yards pottering, weeding and checking their water bore and reticulation sprinklers.

David in Ocean Reef has a shared modern Sumoto submersible water bore with his neighbour.

He called us on 9246 0111 when his bore was not starting on his side but his neighbours was working. They have a Sumoto submersible pump.

We sent out our specialist bore electrician, Dave.

Fixed water bore by replacing fuse in retic box
Fuse in retic controller replaced

The 1 amp glass fuse in the reticulation controller was blown. He replaced and all is working OK.

We suspect there may be an intermittent fault in the 24 volt start wiring of the shared bore coming from the neighbours retic controller

If your Perth water bore or reticulation needs repair call us on 9246 0111 or go to our website here

Water Bore Floreat

We repair and install many water bores and reticulation systems in the Floreat area.

Here we have drilled a water bore and our man Jack returned to connect to the existing reticulation system.

Call for a Water Bore quote 9246 0111

If you live in the Floreat area and would like to save money with a water bore call Virgin Water Bores on 9246 0111 or go to the website HERE

Most new bores we drill in Floreat are between 18 metres and 30 metres in depth depending on the properties elevation. Typically new submersible bores in Floreat cost between $3400 and $5500 depending on depth and size of submersible pump chosen.

Connect retic to new water bore
Connecting the new bore to the existing retic system is usually all part of our job.
Water Bore New in Floreat
We disconnect the existing retic system from mains water before we plumb it in to the new water bore.
Water from new Floreat Water Bore
Virgin Water Bore’s customer now has their bore up and running

Reconnect Water Bore after Renovations

If you have a submersible water bore and you are doing renovations, it is important to consider the water bore as part of your planning.

Old Fremantle Bore

We attended a job in North Fremantle that had an old submersible bore that was working before renovations but had not been reconnected.

Fremantle bore repairs
A bit of detective work and digging around this old bore in Fremantle uncovered what needed doing

We sent our electrician to test the motor and quote the on the cost of re-connection of the submersible water bore.

He found the motor tested OK but that it was an old installation with imperial sizes, no slack on the bore head cable and lots of limestone in ground and concrete around the house. It will be a challenging job to reconnect electrically.

Fremantle Water Bore

Fix bore Fremantle
The submersible bore was in a concrete pit filled with sand and barely visible.

There was a new  start box needed to even test the bore itself was OK electrically as original start box was missing.

Once the bore is back up and running this one is to be wired just for manual operation as the owner intends  to continue using it just manually from a hose. Later if it is connected to automatic reticulation we can install a reticulation controller.

If you are renovating and have a water bore, call us for advice on 9246 0111 or go to our website HERE

We fix bores and retic in all Perth suburbs

We are in Fremantle and surrounds on a daily basis fixing bores and repairing reticulation sprinkler systems. You can also call us for any Perth suburb

Deep Water Bore Heathridge

In our 20 years in the business we have repaired and drilled many modern submersible water bores in the northern Perth suburb of Heathridge.

Our drilling teams specialise in deeper water bites like one we drilled recently in Heathridge that was 52 metres. We understand how to construct the bore so it will silently operate bringing the householder a plentiful supply of water for many years to come.

We pride ourselves on customer service so it was great to get this email.

David was pretty chuffed to get it thanking him for the 52 metre bore drilled in Heathridge just hours after he connected it to the retic.

Thanks Bayer. And well done George!

Drill Water Bore in Driveway

When we are called to a Perth home to repair a water bore, we need to know that location of the water bore hole.

It is great when the home owner knows the location of their water bore. If the home owner has bought a home with a bore they may not know.

The modern submersible water bores have a green lid which can we covered with lawn, garden bed or as you see here aggregate or liquid limestone in a driveway. The water bore is normally drilled in a drive way if there is tight access for the drilling rig in the garden and lawn of the home.

Tight access for water bore - drill in drive way
Water Bore drilled in driveway of Perth home
Water bore covered by green lid
Green lid covering water bore

Adam will cut the bore casing down to below ground level then install the submersible pump and green bore box over the top. Once our electrician has connected it up and we connect to reticulation the paving or the driveway cut out will be put back and everything tidied up.

Water Bore cover
Cover for water bore

It is worth noting that it is the old-style wells that come with a tin lid that looks like a witches hat.

So if you are buying a house with a water bore get as many details as you can about the bore like location and depth so that if your water bore needs repair you can call us on 9246 0111 and we can do the best job possible.