Bore broken, Bore repair

Do I repair my old style well?

You will see many old style wells with a tin lid around Perth. Many are up to 70 years old and some have been dug by the home owner in the ’50’s and ’60’s.

My father dug the well for our family home in Applecross and it is still working.

Applecross bore repair
This old well-style bore is still limping along but will eventually need replacing. A submersible bore will be the way to go.

Many older Perth well style bores still giving faithful service after years of pumping bore water to the garden. Our specialist service team can keep them ticking over with a few industry tricks, priming solutions and centrifugal pump replacements.

Call us on 9246 0111 and we will talk you through the repair of your water bore well style or book a bore service HERE

Sadly though sometimes they are beyond economical repair and need to be “retired”. The best solution can be replacing with a modern submersible bore. Submersible bores have a small green lid which is usually ‘hidden’ under the lawn or garden. Submersible pumps are silent and very economical.

Call Virgin Bores to discuss a new submersible bore for your home and ask us how will it work, how long it will take and how economical will it be. Want to get an idea of cost for a new water bore at your house click HERE

Bore electrician

Bore Repair Kingsley

We have been in Kingsley testing a 1.5 kw Red Jacket pump motor after Daryl rang us with problems with his submersible water bore. It has given faithful service as it is approximately 24 years old.

burnt junction box water bore repair kingsley red jacket pump
Check out the burnt out junction box in this bore in Kingsley. Down hole is a submersible Red Jacket pump.

Ultimately the pump motor tested OK for our specialist bore electrician Dave but the original tests read dead short to earth. He found that the junction box in the borehead was completely burnt out. Dave replaced the junction box for new and all is working again. He did a Tong Test which was at 11 amps well within range.

red jacket bore pump Perth
Initial tests on this submersible bore showed a dead short to earth suggesting that the Red Jacket pump motor had failed.

Dave drilled several holes in the bottom of the junction box to allow water to drop out and not fill up in the future.

We have drilled and repaired a number of modern submersible water bores in the Kingsley area and the surrounding suburbs of Padbury and Woodvale so we understand the ground water conditions in the area. Call us on 9246 0111 or go to our website HERE

Electrical Problems

Electrical Problem with Bore Ballajura

“We have what appears to be an electrical problem with our garden bore at home and would like to arrange for someone to take a look at it”

No problems Paul. Dave our specialist bore electrician attended this job in Ballajura. Electrical tests showed the Sumoto submersible motor was “not fused” and the motor windings were intact but there was a complete dead short to earth.

electrical fault with Ballajura bore pump
Our tests revealed this Ballajura submersible bore had a dead short to earth and the submersible pump motor needed replacing.

We returned and replaced the submersible motor and start box. Now our Ballajura customer is ready for the warm summer months in Perth.

We have been in the bore, pump and retic business for nearly 20 years and have seen just about all the problems that can occur with your water bore. If you live in the Ballajura area and your bore needs repair call us on 9246 0111 or book a bore repair online

Our bore and retic service teams will get your system back up and running fast.

Members ADIA & IAA, Water bore repair

Bore Tripping in Hocking

A modern submersible water bore saves money and is normally low in maintenance.

If something does go wrong with your water bore, call us on 9246 0111 and we will help you fix it and be ready for the hot summer months in Perth.

Dave from Hocking called us because his bore was tripping. We sent our Dave, the electrician, to test the 1.5 kw submersible motor. It tested OK.  The pump was also running OK but after a while the start box overload tripped so Dave bypassed the faulty overload.

Hocking-Blog-3986978796-1540865275817.jpg

Also there were 6 programs with 6 start times in each, now there is only one program with one start time. The reticulation now comes on Wednesday, Friday and Sunday at 6 am for 10 mins on the 7 stations.

So Dave’s sprinklers are now coming on and he is all organised for summer.

General Lawn Sprinkler

So if you are in Hocking or the surrounding areas of Wangara or Wanneroo and your water bore needs fixing call Troy on 9246 0111 or book an online service HERE

Uncategorized

Where does the start box for the bore go?

When we drill a modern submersible water bore we install a bore start box which is the 240 V control equipment for the bore.

Normally the submersible bore start box is next to the meter box or adjacent to the retic controller on an outside wall of the home.

Our bore electrician Dave had a bit of detective work to do to locate the 240v control for this single phase Lowara submersible bore pump in Ballajura. Bore start box located in roofIt was in the roof which was quite unusual.

This call out to Ballajura was to repair a tripping circuit breaker. It was the Lowara motor down hole that was faulty.

We service and repair all types of bore pumps, electrical faults and reticulation in Ballajura and surrounding areas. Call Troy on 9246 0111 or check out our website HERE

Water bore repair

Burnt Plastic in Bore Box

Our bore electrician Dave attended a bore service job in East Fremantle to repair a  water bore reported electrically failing.

The water bore is approximately 50 metres deep with a 1.5 kw Sumoto submersible motor. Dave reported the motor tested OK.

East Fremantle burnt out capacitor
Burnt capacitor in start box

However, the start capacitor in the bore start box was completely blown and part of the start box was melted. So Dave replaced 50MF capacitor for new. He then ran the bore and retic and tested and it was all working OK. Note the ruptured start capacitor. The grey ” gunk” oozing out is typical when a capacitor swells and bursts. This one had burnt and blown more than we normally see. Our customers had smelt the burnt odour walking past the bore control box.

If we can help you with a broken water bore in the East Fremantle, Bicton, Palmyra or surrounds call 9246 0111 or book a bore service online.

Bore broken, Bore Perth

Submersible Bore Tripping Mount Pleasant

James from Mount Pleasant phoned regarding his submersible pump that was tripping the circuit breaker.    (Call us anytime on 9246 0111 if you need help too)

The water bore was drilled in his driveway and it was very useful to know that the paver to show where the bore was located was a different color. As pictured the bore head was was covered by an old concrete lid pit.

Mt Pleasant submersible water bore needs repair
Head of submersible water bore under pavers in driveway

Our senior experienced bore electrician Dave reported the motor was about 8 years old. The 1.1 kw 2 wire subbie motor was dead short to earth and although the motor’s windings appeared to be intact the internal capacitor had ruptured. So we replaced it with a new 1.1 kw sunbmersible pump motor and replaced the start box and junction box.

Bore electrical junction box
We replaced the junction box too. This joins the cables coming up from the pump to the cables going to the house.

We have drilled and repaired many water bores in Mt Pleasant,  Applecross,  Bateman  Ardross and surrounds. We are very experienced with the conditions in the area. If your water bore or retic is in need of repair call us on 9246 0111 or check out our main website HERE

 

 

Reticulation Perth, Reticulation systems, Water bore

New Retic System West Swan

As well as servicing and repairing reticulation and water bores in the West Swan area. Virgin Bores install water bores and reticulation in the Swan Valley and surrounding suburbs including Viveash and Ellenbrook.

This reticulation installation job in West Swan was completed last week. This pretty bush garden is now reticulated and ready for summer. It took our guys David and Jack a few days to complete and everyone was pleased with the result.

If you want to get a new reticulation system in the West Swan area call David on 9246 0111 or get a reticulation quote HERE

Old style well

Old Bore Well Needs Repair Dianella

Jeremy from Dianella phoned us this week saying that the pump on his old style bore well was tripping and was in need of repair.

Our specialist water bore electrician was the man for the job! There was one well liner and it was in the back yard. Most of the bores in the lower lying parts of Dianella are quite shallow. Some up on the hill can be very deep!

old bore Dianella repaired
The isolation switch on the side of this bore well was faulty.

Although the three phase centrifugal pump motor tested OK there was a dead short between phases and the isolator had burnt out wiring.

Bore pump fixed Dianella
This bore pump isolation switch in the well was the culprit

Dave replaced the isolator and renewed all the wiring and the bore pump is working again.

If you have a bore problem and need to get an old style well with a tin lid repaired call us on 9246 0111 or visit our website HERE

Bore repair

Fix bore Greenwood

David from Greenwood phoned us on 9246 0111 last week. We have installed and repaired many modern submersible water bores in the Greenwood, Madeley, Marangaroo and Warwick areas. His submersible pump motor was tripping.

We will talk your problems through on the phone and send the right tradesman so we can fix your modern submersible bore quickly and economically.

In this case we sent Dave our specialist water bore electrician. He has worked on literally thousands of water bores across the Perth metro area.

Greenwood water bore needs repair
Faulty water bore Greenwood

The customer’s  2 wire submersible motor was completely seized, when running it was drawing over 42 amps. It was a totally manual operation with plugs into an adjacent water proof power point which is fed by its’s own circuit breaker/RCD in meter box. All the other bore electrics tested OK.

Modern submersible water bore repaired
Greenwood water bore repair

So we returned to fit new barrel union, new cable down hole and new submersible pump wet-end.

David from Greenwood’s bore and retic are now ready for summer. How about you?

Call Troy on 9246 0111 or book a bore service HERE

 

Our mobile service teams do prompt repairs to ALL TYPES of Water Bores & Reticulation Sprinkler Systems Perth metro-wide. Free phone advice. Our experience saves you time and money. Bore repair HOTLINE 1300 734 300 North of River: Troy 0408454130 South of River: Brett 0411511611

Call Now Button